The ISP1504 is an 8-bit bidirectional UTMI+ Low Pin Interface (ULPI) transceiver, which provides a Hi-Speed Universal Serial Bus (USB) analog front-end solution to Application-Specific Integrated Circuits (ASICs) and Field Programmable Gate Arrays (FPGAs) to implement as a Hi-Speed USB host, peripheral or OTG device.
The ISP1504 evaluation (eval) board allows designers to evaluate the features of the ISP1504, and conduct system-level validation and testing. The eval board interfaces to the link through a 100-pin Transceiver and Macrocell Tester (T&MT) connector that complies with USB 2.0 Transceiver and Macrocell Tester (T&MT) Interface Specification Ver. 1.2.
Fig 1 shows the ISP1504 eval board.
1.功能:
The ISP1504 is fully compliant with Universal Serial Bus Specification Rev. 2.0, UTMI+ Low Pin Interface (ULPI) Specification Rev. 1.1 and On-The-Go Supplement to the USB 2.0 Specification Rev. 1.0a.
The T&MT connector interface is fully compliant with USB 2.0 Transceiver and Macrocell Tester (T&MT) Interface Specification Ver. 1.2.
The VBUS power can be supplied either by the on-chip charge pump or by the on-board power switch.
Configurable active-HIGH or active-LOW reset signal from the link.
Adjustable VCC voltage when powered by the 5 V DC power supply.
Configurable CHIP_SEL_N signal.
Flexible clock source for the ISP1504: on-board crystal, 60 MHz input clock or square wave clock driven into the XTAL1 input.
2.连接器
USB connectors: standard-A (mounted by default), standard-B and mini-AB (mounted by default)
T&MT connector to interface to the link
Input power connector
3.电源
Supplied by the 5 V DC power supply through the input power connector, or
Supplied by the link through the T&MT connector